Ty La1000 Lamp

Posts Tagged ‘Projector’

Question by K C: Where can i find a replacement bulb for a Lenovo c500 projector, without buying the whole lamp for 0?

Best answer:

Answer by James
You have to buy the entire lamp assembly.

Add your own answer in the comments!

Why be different Project 365(2) Day 9


replacement lamp Image by Keith Williamson

by Natalia F.

Question by Yozaz: Projector Lamp burned out?
I have a Toshiba TDP-T45 Projector and the all the images it projects now have a purple tint to them. It’s not the color setting on the machine….could it be the bulb…filters? Anyone experience or remedy this before? Thanks so much.

Best answer:

Answer by PARTHA R
The Picture Tube is perhaps now defective.

Add your own answer in the comments!

The DVD Drive in my 360 Finaly Kicked the Bucket so here is how I fixed it! I Get Replacement Drives and other parts from www.llamma.com ~This was a Toshiba/Samsung drive but the method should be similar for Hitachi & BENQ drives!~

by billjacobus1

Question by ashwani: i have a pansonic big screen projector tv and i want to change lamp?
how to change lamp on pansonic projector tv

Best answer:

Answer by TV Engineer
Usually they just are replaced around the back of the TV. A few screws to undo and the lamp module comes out. Replace it with a genuine manufacturer part and it should be very simple, done within 5 minutes.

A few things to remember:
- Unplug the TV when doing this
- NEVER touch the lamp anywhere with your fingers…oil will get on it and lead to premature failure
- Be sure to put back all screws before powering the TV on. Sometimes there’s sensors on the TV that will know if you haven’t replaced all covers and screws and therefore it won’t let the lamp turn on until this is fixed.

Know better? Leave your own answer in the comments!

www.projectorlampcenter.com Relamping is Bad? Could be, if you don’t know what you are doing. Here are some helpful tips and warnings before you consider Relamping your existing projector lamp.

by Okinawa Soba

Question by Lu: Why are projector lamps so expensive?
I guess ours burned out as it’s not working, and I thought it’d be easy to replace, but it turns out it’s going to cost us close to 0 for a new lamp/bulb. Why are they so much?

Best answer:

Answer by cgi
I think the reason is because the gas inside is under higher pressure. Also they are much brighter than an ordinary bulb. You do not want to handle it without safety glasses and gloves in case it shatters.

Add your own answer in the comments!

For More Info or to Buy Now! www.amazon.com Product Description MP522’s lines are soft and curvaceous; there are no sharp edges anywhere on the exterior. The full-bodied design of the MP522 also represent the myriad of functions that come standard with this model; whether it’s for business,…
Video Rating: 0 / 5

Question by Mazda3 i: what’s the difference between projector lamps and angel eyes?
what’s the difference between projector lamps and angel eyes? I have a 2005 honda civic lx with stock headlamps but after market 10k hid lights. what would look better with it and why? and will my hids still fit? how can i check?

Thanks in advance I know its a lot to answer

Best answer:

Answer by Lost n Found
Angel Eyes : http://upload.wikimedia.org/wikipedia/commons/d/d6/BMW_E39_Angel_Eyes.JPG

Projected Lamps : http://www.pakwheels.com/images/forums/2008/11/4/2_TR7_PakWheels(com).jpg

Angel eyes has fluorescent ring like light which u can attached to your current lamp (may buy ready-made )

Projected lamps doesnt has specific light but lamp itself extruded front from its dark background

Add your own answer in the comments!

www.projectorlampcenter.com Have to buy a projector lamp? Knowing the difference of OEM vs OEM Equivalent projector lamps could save you hundreds of dollars! We hope you enjoy these brief tips on projector lamps.

Question by Brooklynboy: Can you fit an HID bulb in a factory 2006 Lexus IS 250 halogen projector socket ?
I have a 2006 Lexus IS 250 and would like to purchase a Philips HID Conversion Kit. My current IS has the standard halogen headlights with the projector lamps. Will these new HID bulbs fit into my current IS’ headlight lamp? I know that HID bulbs are bigger then halogens so I’m a little skeptical. But on the other hand the IS also is available with HID headlights and the lamps look exactly the same.

Best answer:

Answer by uthockey32
All the kits I have seen have an adapter to fit the headlight on your car, Be very careful when you wire it up. These put out a lot of AMPS and it can stop your heart.

Give your answer to this question below!

Changing a Projector Lamp, Quick and EasyCarefully change this lamp by following the instructions decribed in this movies. Established in 1998, APLUSLAMP.COM was the first specialist distributor of projector Lamps anywhere in the world. With distribution partners in many of the smaller territories APLUSLAMP.COM reaches nearly every corner of the planet and is by far the largest projector lamp distributor in the world. We only deal in lamps that are genuine and provide original product performance, we do not sell copy or branded alternatives that under perform and compromise your reputation with your customer. Welcome to APLUSLAMP.COM Thanks
Video Rating: 0 / 5

Question by Atul: Can i use 100`s of LED in my projector insted of lamp?

What is the other source which i can use insted of lamp, as lamp costs too much. Is there any other cheap source ??
What is the other source which i can use insted of lamp, as lamp costs too much. Is there any other cheap source ?? My projector is HITACHI CP-X958 LCD Projector! 1400 Lumens

Best answer:

Answer by St. Valentine
No…

Well, yes, if “quality” isn’t a big deal to you. I think it may project about 2 feet with LED’s.

Add your own answer in the comments!

This video shows how to replace the lamp in an InFocus SP-LAMP-006 projector lamp housing.
Video Rating: 3 / 5

Question by Enjoi: ahh, stupid projector… i neeeed help!! Lamp/Bulb Replacement?
i can’t really tell if my lamp or bulb is out on my projector, but it keeps turning off after about thirty seconds of use. pretty lame. anyways, it fires up as it would normally, the image is huge and bright, very vivid, but it will NOT stay on. i have no idea what to look for in order to tell what part needs replacement, and if to your knowledge (can you help me figure out what’s wrong), can you please tell me how to replace the lamp in the projector. i have a Mitsubishi Hc900. pleeease help!!!

thank you for any information and help given!!!!!!!!!

Best answer:

Answer by agb90spruce
If the lamp comes on, it’s not a burnt out lamp. Sounds like it could be a protection ciruit thing due to, for example, overheating.

Make sure there is free space around the projector, and the air filter is clean. Check the manual for how.

I assume the cooling fan is working?

If it’s not cooling related it’s probably more serious and you may have to look for service.

Good luck.

Give your answer to this question below!

2009JUN1155


replacement lamp Image by bootload

by Lady T 220

Question by sandy w: where can i get an Optoma Projector Lamp replaced in phoenix az?
model ep 731

Best answer:

Answer by agb90spruce
RJO Electronics in Mesa is an Optoma sales and repair firm.

That said, lamps are usually consumer replaceable and you could purchase one from one of the internet sites listed at the second link below. Instructions are in the owners manual.

Details of the lamp you need are:
Item #: BL-FP150B
Fits: EP731
UPC: 796435 21 913 0

Add your own answer in the comments!

Modified Projector lamp in mitsubishi LVP-X70UX fits SHP lamp that not for this model inside this projector.
Video Rating: 0 / 5

by Gilderic

Question by thegame!!: projector….?
i bought this used projector(panasonic Lcd,model # pt-l592u)and the lamp is almost done……so can i replace it with any lamp or dose it have to be the exact thing…..thanx

Best answer:

Answer by JP
The lamps in a projector (atleast quality units) is NOT a standard lamp. They are designed to maintain the same color balance even while they fade. So the end result is the same color on screen but simply a darker image. This is one of the reasons they are so expensive.

Contact Panasonic and get a replacement.

What do you think? Answer below!